Xcessive Manufacturing

MX83 to JZ Motor Mount Brackets ('89-'90 Zenki)

Toyota Cressida MX83 Motor Mount Brackets, Fits 1JZ & 2JZ with Zenki X-Memeber ('89-'90)

Availability: In stock




Xcessive Manufacturing's new steel corrected geometry mount brackets for JZ blocks are designed with specific angles for the '89-'90 Cressida Zenki front cross member and a slotted motor mount point hole that allows movement of the engine forward or backward around an inch. Placement is typically dictated more by the trans cross member.

CNC cut from 1/4" steel plate, formed and plated, these engine brackets will handle all the punishment you can throw at them and last a life time doing it. If your doing 1J or 2J swap into a Cressida, these will do the job. Sold in pairs with all the bolts for both sides, (1st picture)

Stock rubber mounts will require the index pin to be ground off to allow these brackets to properly sit flat due to the application of the slotted mount.

These mounts are designed for the cross member typical to the Zenki '89-'90 Cressida and do not match the angle found on the '91-'92 Kouki style Cressida and will cause premature failure of the motor mounts if used for the wrong application. You may need to check the production year on the early Zenki chassis. Some cars produced from 8 of 1990 will have the Kouki crossmember. You can contact us if you have this concern on how to identify it.

Pictures 1 and 2 are current production, pictures 3 and 4 are for placement reference on the engine only and are not current production versions.

These mounts do not fit the GX81 Cross Member


Write Your Own Review

Only registered users can write reviews. Please, log in or register



Use spaces to separate tags. Use single quotes (') for phrases.