Xcessive Manufacturing

Urethane Motor Mount - Series 3

Series 3 - 2.85" tall with two 10mm studs

Availability: In stock




Series 3 - 2.85" tall with two 10mm studs

These mounts are designed as a direct fit replacement for the S13, S14 and S15 chassis. We also use them in our FT86 and WRX/STI to JZ swap kits.

We've designed these mounts to be a direct replacement for those soft, worn out rubber mounts. We set them up standard with stiffer 80A (Orange) Urethane bushings but also offer 65A (Yellow) softer bushings.

The 80A urethane bushings are firmer than Nismo type mounts, so expect an increase in the transfer of engine "noise" into the car. If you want the 65A bushings, please specify at the time of order.

Want to lower your motor in your S chassis by 3/8"? Check out our Series 15 mounts (UH-UMM-S15).



Sold as a pair with 80A bushings.

Stock fitment on S Chassis Nissan

Significantly less movement of the engine

These are the same mounts we supply on our FT86 JZ motor swap brackets.

Full floating omni-directional dampening unlike "puck" type mounts with a single through bolt. The bolt causes full metal contact from top to bottom.

Optional 65A (Yellow) bushings available by request

Easy replacement bushings

All new components

Comes with all required hardware to directly replace stock mounts on S Chassis


Write Your Own Review

Only registered users can write reviews. Please, log in or register



Use spaces to separate tags. Use single quotes (') for phrases.