Brake Master Cylinder heat shield - 240SX

   Xcessive Manufacturing's stainless steel heat shield is made from heavy gauge polished T304 stainless for maximum heat reflection and good looks with no chrome to flake off. Designed with an easy slip on installation that requires only one wrench to install and no removal of any factory hardware, this may be the easiest piece you may ever install.

   Shielding your brake master cylinder is an absolute must if you run a turbo on your 240. Most down pipes or headers put the hot exhaust gas right next to the brake master cylinder and brake lines, which causes the brake fluid to boil and induces air into the brakes. Even worse is when the reservoir melts causing the brake fluid to spill out not only loosing your brakes but potentially causing a fire when the fluid splashes onto the hot exhaust. Don't take that chance, all ways wear protection!!