Toyota MX chassis Heim Tie Rod adapters- Long version

These are the same as our other heim tie rod conversion, just longer for use with wider controll arms and variying steering configurations like zero Ackerman steering arms. We've made these MX chassis Heim tie rod adapters to fit into the stock taper found on the steering knuckles and thread directly onto the inner tie rods. They can be used with stock steering components or aftermarket arms that fit the stock taper tie rod mount. We've made heim adapters to allow for up to approximately 15mm of drop on the pivot point for the tie rod giving a reduction in bump steer above that of just running RCA's. These must be run on lowered cars of approximately 2" to 3" drop, the angle found on stock height cars will cause a bind in heim joint and cause damage or failure of parts. Sold in pairs, Inner tie rods and steering arms not included. These are the long rod ends and couplers designed to work on wide track front suspension and both of our quick ratio steering arms, standard and Zero Ackerman. These tie rod adapters will go up to 2" wider per side with our Zero ackerman steering arms when used with MX83 inner tie rods.