AE86 Steering rack and parts

When you want to put a fast ratio manual rack in your car, there aren't a lot of options, this manual rack is a good way to go.

These all new racks are made to fit the AE86 Corolla front crossmember with a 2.5 turn lock to lock ratio for fast, accurate steering. They work quite nicely in our front cross members!

Built to factory Corolla specs, we've also sourced new inner tie rods and boots as well as the hard to find small spline steering universal joint. If you're converting from power steering, you'll need this joint. If you're replacing a worn out rack, you may just want to check your universal joint for age and wear.

It's important to note that the manual racks are a bit shorter at the input shaft then the power racks, so you will need to pull your lower steering shaft out a bit to get the lower universal joint to fit up properly. If you're concerned that you may just pull it out to far, we also have a new steering shaft that's longer.

  We also offer urethane rack bushings if you want to tighten up the rack while you're in there as well as new rack straps if you need those as well.

It should also be noted that the power racks have a longer inner tie rod then manual racks and thusly shorter outer tie rods. The inner tie rods we sell are a longer version to be used with the shorter FWD Corolla outer tie rods. If you use the longer RWD outer tie rods, the combination will be to long unless you're extending your LCA's quite a bit.

Bushing color is Green.