FT86 (FRS-BRZ) to JZ Motor Mount Brackets **NON VVTi**

This is the same motor brackets as our complete kit, just without our Urethane mounts.

These mounts do not work with VVTi blocks that only have a forward mount location on the passenger side. See the third picture for the passenger side rear position required.

The slotted brackets allow some adjustment front to rear for firewall clearance or you can set motor back a bit farther if you modify the firewall, there's just not a lot of room in the engine bay for an inline 6.

The engine and stock intake manifold will fit under the hood when the bracing is cut out but a turbo or intake piping may be of concern at the 3/4" crossmember clearance. The engine pictured was installed with 3/4" mounts for a swapped steering rack and a G-Force transmission with an Xcessive transmission adapter and no modifications to the transmission tunnel. Modifying the trans tunnel and raising the trans will give more hood clearance at the front of the motor.
Toyota FT86 (FRS-BRZ) Motor Mount Brackets for JZ swaps **Urethane mounts not included in this kit**

Kit Includes
RH and LH Motor brackets
Block Bolting hardware